Pre-Programmed Watch Winder

Remove the cuff from the winder drum by pulling firmly on the two tabs. Close the  trap or bracelet of your watch. Compress the cuff and slide your watch over the cuff, watch dial facing outwards. Push the cuff into the drum until it locks into place, an audible click will be heard.

To start the rotation program, plug the adapter in, and turn the power switch to "ON" position.  Please note that the LED will keep blinking during the rest and pause periods of the rotation program. This shows that the program is in operational mode. To stop the rotation program turn the switch to "OFF'.

This Module 1.8 winder comes with a power adapter (AC/DC 5.0-volt output) and will also run on "AA" cell batteries. The winder will automatically switch to main power if both power sources are connected.

Your watch your rules. You can set your watch to start in any position and it will return home to the same position when the cycle is complete.

The first time you turn your winder on you will notice that the drum rotated and then rests. The drum will always stop at this position, during and at the end of all cycles.

That means that if you place your watch inside the drum so the position is 12 o'clock, the watch is at the top, and then during all test cycles, your watch will come to a rest at the 12 o'clock position. You can choose any position you like.

Note that this winder will not wind your watch continuously. The computer chip inside has been programmed to wind your watch on an intermittent  basis only, with extended "pause" and "sleep" phases. This is for the protection of the mainspring of your watch.