Rocket Travel Watch Winder

1. Turns per day: 900 TPD (Bi-Direction) with 12 o’clock start/stop position function

2. Built-in Dual Sensors Gearbox for precision Turns Per Day (TPD) counting

3. Monitor winder status from the three LEDs on the semi-transparent metallic band

4. Single Switch Operation

5. Built-in rechargeable Lithium Battery with USB Type-C charging port

6. New Compact Design Cuff for easy watch mounting

A slide switch is placed at the back of the winder; you can use it to turn on or off the winder.

When you turn on or off the winder, the drum rotates and stops at a predefined (12 o'clock) position. The drum will always rest at this position throughout the start and end of all cycles. You can insert the watch- mounted cuff into the drum; it will rest at this position during all rotation cycles.

The preprogrammed winder rotation program includes rotation time and rest time last for 24 hours. The winder rotates 900 turns per day in both clockwise and counter-clockwise directions at a speed of 6 rotations per minute (rpm). When you switch on the winder, the drum will return to the 12 o’clock position and stay there for 10 seonds for you to insert the cuff.

After the 10 seconds, it will start to otate in the clockwise direction for 180 rotations followed by 180 rotations in the counter-clockwise direction; it will rest at the 12 o’clock position for 25 minutes. This process will repeat five times and the drum will stay at the 12 o’clock position for approximately 17 hours. Then, the winder will start a new winder rotation program

Once you turn on the winder, the Green LED in the metallic band starts dimming on and off. Turn off the winder will turn off the LED completely.

When the battery is being charged, the Blue LED in the metallic band starts dimming on and off. It stays on permanently when the battery is fully charged. The Blue LED will be off if you unplug the power source from the winder.

The Red LED in the metallic band will blink one time periodically if the battery is low. It will pulse to blink three times if there is a speed sensor error and will pulse to blink four times if there is a position sensor error.

The winder packs with a USB power adapter (5V/1A output) and a 1.5m (USB Type C to Type A) cable.

To charge the winder, you can plug the power adapter into the mains and insert the USB cable into the winder.

When you turn on or off the winder, the drum rotates and stops at a predefined (12 o'clock) position. The drum will always rest at this position throughout the start and end of all cycles. You can insert the watch- mounted cuff into the drum; it will rest at this position during all rotation cycles.